Hi Steve,
This is SSV but not the standard model. This was made for a windmill tower. It
will support 50 sq ft at the top with 70 mph wind.
Greg Best
Sent from my iPhone
> On May 9, 2017, at 6:20 PM, Steve Maki <lists@oakcom.org> wrote:
>
> Greg,
>
> Are you sure this is Rohn SSV tower?
>
> The taper you describe - 7' over 80' - is much more extreme than normal SSV
> sections, which have 2' taper over 80'.
>
> -Steve K8LX
>
>> On 5/9/2017 0:19 AM, Greg Best wrote:
>>
>> Hello. I am new to the reflector and have some questions about erecting an
>> SSV tower. Mine is somewhat unique in that it was a windmill tower so it is
>> a beast. It is a used tower but in very good shape but very few assembly
>> drawings exist. The tower is only 80 ft tall composed of 4 sections. The
>> bottom spread is about 8 ft and the top is only 1 foot.
>
> <snip>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|