Greg,
Are you sure this is Rohn SSV tower?
The taper you describe - 7' over 80' - is much more extreme than normal
SSV sections, which have 2' taper over 80'.
-Steve K8LX
On 5/9/2017 0:19 AM, Greg Best wrote:
Hello. I am new to the reflector and have some questions about erecting an
SSV tower. Mine is somewhat unique in that it was a windmill tower so it is
a beast. It is a used tower but in very good shape but very few assembly
drawings exist. The tower is only 80 ft tall composed of 4 sections. The
bottom spread is about 8 ft and the top is only 1 foot.
<snip>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|