Towertalk
[Top] [All Lists]

[TowerTalk] tower base rod weatherproofing

To: <towertalk@contesting.com>
Subject: [TowerTalk] tower base rod weatherproofing
From: "Jim Thomson" <jim.thom@telus.net>
Date: Sat, 29 Apr 2017 23:13:53 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Date: Thu, 27 Apr 2017 17:39:33 -0500
From: "bob" <w9zv@comcast.net>
To: <towertalk@contesting.com>
Subject: [TowerTalk] tower base rod weatherproofing

<I have some non-galvanized bolts/rods embedded into a concrete base for a
<short tower mounting plate.
<What would you recommend to coat them in to keep corrosion/rust demons away?
They are composed of hardened 5/8 x 18 threaded rods (non-galvanized) and
the bolts are used for adjusting the tower for plumb, so I'd like to
preserve the ability to adjust them at some point again.  So something that
would leave the nuts still adjustable down the road is preferable, even if
has to be re-sealed/coated at that time its fine.

 

Suggestions? 
-bob

##  Why would you want to use non galvanized anchor rods in the 1st place? 
You cant do anything about the portion embedded in the concrete..after the 
fact. 
The portion above the concrete.....  you could use several coats of cold spray, 
since
it drys very fast, like in 15 mins or less.   The rustoleum brand, sold at home 
depot
works superb..better than any of the other brands I have bought at the local 
machine shops. 
Then slobber it all with marine grade never seize....Loctite brand makes
the never seize..and also the marine grade never seize.    You could also 
probably coat
the entire top surface of the concrete with the correct product, to minimize 
moisture 
ingress  into the top surface of concrete. 

Jim  VE7RF
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>