Ok that makes a big difference. ! thanks Simon
Bob
K6UJ
On 10/30/16 8:48 PM, Simon Lewis wrote:
BTW those ones you linked to are $24 for a pack of 20 – not each !
Sent from Mail <https://go.microsoft.com/fwlink/?LinkId=550986> for
Windows 10
*From: *Simon Lewis <mailto:gm4plm@hotmail.com>
*Sent: *Monday, 31 October 2016 4:44 PM
*To: *Bob K6UJ <mailto:k6uj@pacbell.net>; towertalk@contesting.com
<mailto:towertalk@contesting.com>
*Subject: *RE: [TowerTalk] Need US source of fence wire clamps
I can buy them for $ 1 NZD a piece shipped here in NZ!
If anyone wants some I can buy some for cost + shipping in a padded
envelope
!
Sent from Mail <https://go.microsoft.com/fwlink/?LinkId=550986> for
Windows 10
*From: *Bob K6UJ <mailto:k6uj@pacbell.net>
*Sent: *Monday, 31 October 2016 4:40 PM
*To: *towertalk@contesting.com <mailto:towertalk@contesting.com>
*Subject: *Re: [TowerTalk] Need US source of fence wire clamps
Martin,
The ones I have found so far are too expensive for my taste. Heres one
for $24.00
http://www.speedriteenergizers.com/products/heavy-duty-joint-clamp
Like you, I need only to join two parallel wire with a clamp. I found
these which look like they
will do the job. They call them heavy duty joint clamps.
http://www.livewireproducts.com/product-category/permanent-fence-supplies/page/3/
Bob
K6UJ
On 10/30/16 7:38 PM, Kirk Kleinschmidt via TowerTalk wrote:
> I'd like to find these, too, but I suspect that, based on the mfr
website, they're really not set up for convenient sales at reasonable
prices, etc (or we'd already be able to find them :)
> I need something like this to clamp sections of galvanized ground
screen together. I found some round ones at Menard's and Tractor
Supply, but they don't look as good and they're about $2 each.
> If I can't find a source, I'm going to use a small galvanized bolt
and a pair of galvanized washers to clamp my ground screen sections
together.
> My "wires" are almost exclusively parallel, so I don't need to
attach wires coming in from 90 degrees, etc.
> My ground screens are semi-temporary, so I don't care too much if I
have to replace them every season or three. When I finalize the
locations of a couple of towers / verticals I might replace the
screens with regular radials. But maybe not. :)
> Thanks,
> --Kirk, NT0Z Rochester, MN My book, "Stealth Amateur Radio," is now
available from www.stealthamateur.com <http://www.stealthamateur.com>
and on the Amazon Kindle (soon)
>
> On Sunday, October 30, 2016 7:22 PM, Martin A Flynn
<maflynn@theflynn.org> wrote:
>
>
>
> https://www.stafix.com/en-us/product/heavy-duty-claw-joint-clamp
>
> martin
>
> W2RWJ
>
>
> On 10/30/2016 6:49 PM, Bob K6UJ wrote:
>> please post the info on the reflector guys. I would like to find
>> these too.
>>
>> Bob
>> K6UJ
>>
>> On 10/29/16 10:49 AM, Raymond Benny wrote:
>>> The clamps that GM3SEK mentions look good for connecting fence wire
>>> together, but I have not been able to find a US source so far.
Here they
>>> are: http://www.rappa.co.uk/products/151-four-way-line-clamp-25-pack.
>>>
>>> There seem to be some other varieties of these clamps, but
>>> individually the
>>> are expensive. Any USA sources or other suggestions?
>>>
>>> Ray,
>>> N6VR
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|