BTW those ones you linked to are $24 for a pack of 20 – not each !
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
From: Simon Lewis<mailto:gm4plm@hotmail.com>
Sent: Monday, 31 October 2016 4:44 PM
To: Bob K6UJ<mailto:k6uj@pacbell.net>;
towertalk@contesting.com<mailto:towertalk@contesting.com>
Subject: RE: [TowerTalk] Need US source of fence wire clamps
I can buy them for $ 1 NZD a piece shipped here in NZ!
If anyone wants some I can buy some for cost + shipping in a padded envelope
!
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
From: Bob K6UJ<mailto:k6uj@pacbell.net>
Sent: Monday, 31 October 2016 4:40 PM
To: towertalk@contesting.com<mailto:towertalk@contesting.com>
Subject: Re: [TowerTalk] Need US source of fence wire clamps
Martin,
The ones I have found so far are too expensive for my taste. Heres one
for $24.00
http://www.speedriteenergizers.com/products/heavy-duty-joint-clamp
Like you, I need only to join two parallel wire with a clamp. I found
these which look like they
will do the job. They call them heavy duty joint clamps.
http://www.livewireproducts.com/product-category/permanent-fence-supplies/page/3/
Bob
K6UJ
On 10/30/16 7:38 PM, Kirk Kleinschmidt via TowerTalk wrote:
> I'd like to find these, too, but I suspect that, based on the mfr website,
> they're really not set up for convenient sales at reasonable prices, etc (or
> we'd already be able to find them :)
> I need something like this to clamp sections of galvanized ground screen
> together. I found some round ones at Menard's and Tractor Supply, but they
> don't look as good and they're about $2 each.
> If I can't find a source, I'm going to use a small galvanized bolt and a pair
> of galvanized washers to clamp my ground screen sections together.
> My "wires" are almost exclusively parallel, so I don't need to attach wires
> coming in from 90 degrees, etc.
> My ground screens are semi-temporary, so I don't care too much if I have to
> replace them every season or three. When I finalize the locations of a couple
> of towers / verticals I might replace the screens with regular radials. But
> maybe not. :)
> Thanks,
> --Kirk, NT0Z Rochester, MN My book, "Stealth Amateur Radio," is now
> available from www.stealthamateur.com<http://www.stealthamateur.com> and on
> the Amazon Kindle (soon)
>
> On Sunday, October 30, 2016 7:22 PM, Martin A Flynn
> <maflynn@theflynn.org> wrote:
>
>
>
> https://www.stafix.com/en-us/product/heavy-duty-claw-joint-clamp
>
> martin
>
> W2RWJ
>
>
> On 10/30/2016 6:49 PM, Bob K6UJ wrote:
>> please post the info on the reflector guys. I would like to find
>> these too.
>>
>> Bob
>> K6UJ
>>
>> On 10/29/16 10:49 AM, Raymond Benny wrote:
>>> The clamps that GM3SEK mentions look good for connecting fence wire
>>> together, but I have not been able to find a US source so far. Here they
>>> are: http://www.rappa.co.uk/products/151-four-way-line-clamp-25-pack.
>>>
>>> There seem to be some other varieties of these clamps, but
>>> individually the
>>> are expensive. Any USA sources or other suggestions?
>>>
>>> Ray,
>>> N6VR
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|