Bill and all,
My crank up is bolted to three 3/4" diameter lengths of all-thread held in
place in 7/8" holes (prepared as specified by the manufacturer) using
Simpson Strong Tie two part construction adhesive. I used the two tubes and
dual-caulk gun type device with the mixing nozzle. Worked out perfectly.
The bond is stronger that the steel.
Mickey N4MB
On Tuesday, March 8, 2016, Bill <bmarx@bellsouth.net> wrote:
> What is the correct epoxy please?
> Bill W2CQ
>
> On 3/8/2016 3:41 PM, K7LXC--- via TowerTalk wrote:
>
>> I have an existing 25G tower base that is damaged and needs replacing.
>>>
>> Two of the four existing bolts align to the new base - What experience
>> and
>> advice would the group offer regarding drilling the concrete, inserting a
>> bolt and epoxy it in ?
>> Easy peasy. Just do what you describe and you'll be all set.
>> Contractors do this sort of thing everyday.
>> Cheers,
>> Steve K7LXC
>> TOWER TECH
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
Mickey Baker, N4MB
Fort Lauderdale, FL
*“Tell me, and I will listen. Show me, and I will understand. Involve me,
and I will learn.” *Teton Lakota, American Indian Saying.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|