Towertalk
[Top] [All Lists]

[TowerTalk] Fwd: Guying Alum Tower

To: towertalk@contesting.com
Subject: [TowerTalk] Fwd: Guying Alum Tower
From: Hans Hammarquist via TowerTalk <towertalk@contesting.com>
Reply-to: Hans Hammarquist <hanslg@aol.com>
Date: Wed, 9 Dec 2015 12:20:14 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Buy guying my tower the wind survival went from 80 to 135 mph @ 20 sq feet 
surface area on the top.


Hans - N2JFS



-----Original Message-----
From: john <john@kk9a.com>
To: towertalk <towertalk@contesting.com>
Sent: Tue, Dec 8, 2015 6:59 am
Subject: Re: [TowerTalk] Guying Alum Tower

Well stated Jim.  I have used guys on aluminum towers. I believe that it
made the structure stronger and it certainly made it more comfortable to
climb. The Universal Tower catalog shows their tower with guys (at least
it used to) but it offers no guidance on doing this.

John KK9A


To:     towertalk@contesting.com
Subject:        Re: [TowerTalk] Guying Alum Tower
From:   K6OK via TowerTalk <towertalk@contesting.com>
Reply-to:       K6OK <jvarn359@googlemail.com>
Date:   Mon, 7 Dec 2015 17:13:33 -0800


Rick N6RK is right on the money, there can be a significant benefit in
guying aluminum towers that were originally sold as standalone towers. In
fact, aluminum towers benefit from guying more than steel towers do. This
is because aluminum is 3x more elastic than steel, causing the tower to
bend more away from the vertical in the wind (P-delta effect). The more a
tower bends, P-delta grows, leaving less capacity available for antennas.
Guy wires help keep the tower vertical, reducing P-delta, allowing more
capacity for antennas.

But guying aluminum towers should not be done by rule of thumb or seat of
the pants. To ensure success an engineering analysis by a PE is needed.
Aluminum towers are finicky. Every place where the Z-brace is welded to the
legs, there is a "heat affected zone" near each weld where the yield
strength drops from 35ksi to 15ksi (assuming 6061-T6). Placement of guy
wire attachment points, both the height above ground and relative to the
welds, are critical. Stresses at every weld zone need to be checked.

73 Jim K6OK

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>