http://www.dxzone.com/cgi-bin/dir/jump2.cgi?ID=17127 is useful too.
Don W7WLL
-----Original Message-----
From: David Gallatin via TowerTalk
Sent: Monday, November 09, 2015 12:56 PM
To: Robert Harmon ; towertalk@contesting.com
Subject: Re: [TowerTalk] Mast Calculator ??
The DX calculator is cool to use BUT it is only designed to be accurate with
their chrome-moly pipe specs whereas the WD9P allowed you to plug in your
own. 73, David,
AA9G ex W5DCG and KC9EEV
From: Robert Harmon <k6uj@pacbell.net>
To: towertalk@contesting.com
Sent: Monday, November 9, 2015 9:52 AM
Subject: Re: [TowerTalk] Mast Calculator ??
Try out DX Engineering's mast calculator :
http://www.dxengineering.com/mastloadestimator
73,
Bob
K6UJ
On 11/9/15 6:27 AM, Jim Thomson wrote:
Date: Sun, 8 Nov 2015 18:25:47 +0000 (UTC)
From: Mike Fahmie <wa6zty@yahoo.com>
To: Towertalk Reflector <towertalk@contesting.com>
Subject: [TowerTalk] Mast Calculator ??
What has become of WD9P's Mast Calculator that used to reside at:
http://www.math.niu.edu/KARC/mast/
I found this very useful and I had a high confidence factor in it.
-Mike-WA6ZTY
## use the free ARRL mast calculator, its dead on accurate.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|