The DX calculator is cool to use BUT it is only designed to be accurate with
their chrome-moly pipe specs whereas the WD9P allowed you to plug in your
own. 73, David,
AA9G ex W5DCG and KC9EEV
From: Robert Harmon <k6uj@pacbell.net>
To: towertalk@contesting.com
Sent: Monday, November 9, 2015 9:52 AM
Subject: Re: [TowerTalk] Mast Calculator ??
Try out DX Engineering's mast calculator :
http://www.dxengineering.com/mastloadestimator
73,
Bob
K6UJ
On 11/9/15 6:27 AM, Jim Thomson wrote:
> Date: Sun, 8 Nov 2015 18:25:47 +0000 (UTC)
> From: Mike Fahmie <wa6zty@yahoo.com>
> To: Towertalk Reflector <towertalk@contesting.com>
> Subject: [TowerTalk] Mast Calculator ??
>
> What has become of WD9P's Mast Calculator that used to reside at:
>
> http://www.math.niu.edu/KARC/mast/
> I found this very useful and I had a high confidence factor in it.
>
> -Mike-WA6ZTY
>
>
> ## use the free ARRL mast calculator, its dead on accurate.
>
> Jim VE7RF
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|