Thank you for the quick replies. Since we had rain forecast for today, I went
out last night and sealed them with liquid electrical tape I keep on hand.
Seemed to work very well. This morning I see someone else offered the same
solution.
Thanks again!!
J D Lambright - KF5U
Sent from my iPhone
> On May 24, 2015, at 10:12 PM, J D Lambright <jdlambrightatty@gmail.com> wrote:
>
> I just finished assembling my M2 40M4LLDD 40 meter Yagi. The element
> supports use Phillystran HPTG-1200.. I've heard that the inner fiber core of
> Phillystran is highly affected by water intrusion, but the manual makes no
> mention of sealing or capping the ends of the Phillystran.
>
> Do I need to seal or cap the ends to protect against water intrusion? If so,
> what is the preferred way to do this?
>
> Thank you,
> J D Lambright - KF5U
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|