Guys-
Wondering if anyone has experimented with rolling a small rubber O ring on the
end of an SO239 connector before putting the PL259 on it? It seems that if you
got the right size O ring it could seat under the PL259 and create a good seal
there.
Sometimes there isn't a lot of length on the SO239, and the shell of the PL259
practically bottoms out on the flange of the SO239, and therefore wrapping
black tape around the end of the PL259 can't really get a good seal between the
two because there just ins't enough room. (I've been using liquid electrical
tape for this and it seems really good so far.)
Chris
KF7P
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|