A PL259 connector shell is ~3/4" diameter, Type N's are slightly larger. Aim
for at least 20mm tubing if your meaning to seal those.-Mike-WA6ZTY
From: Bill Turner <dezrat@outlook.com>
To: Towertalk <towertalk@contesting.com>
Sent: Wednesday, November 5, 2014 5:10 PM
Subject: Re: [TowerTalk] Adhesive lined heat shrink for connectors
------------ ORIGINAL MESSAGE ------------(may be snipped)
On Mon, 03 Nov 2014 12:08:40 -0500, Mike wrote:
>
>Thanks for the suggestions Tom. I tried searching for 'flooded' heat
>shrink but found I had better luck searching for 'lined' heat shrink.
REPLY:
On eBay, you could search for "adhesive heat shrink". Currently there
are 1,575 listings.
I just started using the 1/2 inch size myself for coax. So far, so
good.
73, Bill W6WRT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|