My experience over the years has been outstanding dealing with MFJ.
Thanks to them we have low cost antenna analyzers and other products. The
few times I have had an issue their customer service has been highly beyond
expectations! . . .In spite of what some disgruntled old curmudgeons might
rant about.
THANKS MFJ!
W5JCS
On Sun, Aug 31, 2014 at 5:30 PM, Joe Subich, W4TV <lists@subich.com> wrote:
>
> The issue is that customer service costs money. MFJ have priced
> themselves into a corner ... they can improve quality so their
> products are more reliable and require less service, they can increase
> prices to build in margins to support an appropriately sized service
> operation, or they can simply say up front that the devices are "not
> economically repairable." In any case it means higher prices and MFJ
> have always been defined by low price not high quality.
>
> If one has well trained, competent and properly equipped technicians
> the "loaded cost" for the labor alone is going to be somewhere between
> $50 and $100 per hour. With a half-hour just to unpack, open, close,
> and repack a product returned for non-warranty service, it doesn't
> take a lot to run up a repair bill greater than the manufacturing cost
> of a $299 list price antenna analyzer or a $239 list price antenna
> switch controller.
>
> What is the proper balance? That's up to MFJ and each customer to
> determine for himself.
>
> 73,
>
> ... Joe, W4TV
>
>
> On 2014-08-31 5:37 PM, Tom Nicholson wrote:
>
>> Craig,
>> I would wager that the vast majority of people here would agree
>> with you that MFJ employees, most probably, are all "good guys" and well
>> intended in the pursuit of making available a source of equipment for
>> the Ham Radio community. Where management has failed is the support
>> "after the sale"! Many fine products have failed as a result of poor or
>> no product support. The lack of support is no reflection on the
>> dedication and expertise of the support personnel, What it is a
>> reflection of is the mismanagement of the support system. This CAN be
>> remedied, BUT maybe at the cost of some management jobs. They need to
>> have the management team address these problems or replace the team. It
>> seems at MFJ it has reached "critical mass" and the statement has to be
>> made:
>>
>> "You are either part of the solution or you are part of the
>> problem" and make the hard decisions from that point forward.
>>
>> YMMV, but that has been my experience over the 30+ plus years that
>> I owned a business that was 20% sales and 80% customer service.
>>
>> 73
>> Tom W1ALZ
>>
>>
>>
>> On 8/31/2014 3:34 PM, Craig Clark wrote:
>>
>>> When you bash MFJ, just remember, if it was not for them, we would
>>> have no:
>>>
>>> Hy-Gain
>>> Cushcraft
>>> Ameritron
>>> Mirage
>>> Vectronics
>>> Ed Noll and many other books
>>>
>>> And probably a few others that I can't remember.
>>>
>>> I have known and worked with MFJ for over 35 years. Say what you will,
>>> they
>>> are the good guys.
>>>
>>> Back to towers and antennas.
>>>
>>> Craig
>>>
>>>
>>> Craig Clark K1QX
>>> PO Box 209
>>> 107 Fitzgerald Rd
>>> Rindge NH 03461
>>> (603) 899-6103 office
>>> (603) 520 6577 cell
>>>
>>>
>>>
>>>
>>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|