Towertalk
[Top] [All Lists]

Re: [TowerTalk] KT36 Balun

To: "Jim W7RY" <w7ry@centurytel.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] KT36 Balun
From: "Jim W7RY" <w7ry@centurytel.net>
Reply-to: Jim W7RY <w7ry@centurytel.net>
Date: Sat, 26 Apr 2014 21:00:03 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
The KT-36 is 200 ohms feed point impedance. Not 50 ohms. I though I better clarify.

73

Jim W7RY


-----Original Message----- From: Jim W7RY
Sent: Saturday, April 26, 2014 7:43 PM
To: towertalk@contesting.com
Subject: [TowerTalk] KT36 Balun

Which balun do you recommend for the M2 KT36? A voltage balun or a current balun? I run 1500 watts during RTTY contests.

I’m planning on winding my own. I have Jerry Sevick’s book on building them.

Thanks!
73
Jim W7RY
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>