I had a piece that was about three inches. I cut the part that wrapped
around the ground rod to about 1.5 inches and wrapped it around the rod,
securing it with several stainless hose clamps.
Bill K4XS/KH7XS
In a message dated 10/14/2013 12:54:01 A.M. Coordinated Universal Ti,
john@kk9a.com writes:
I have used a number of the Polyphaser and DX Engineering ground clamps.
Unfortunately they are designed for 0.625" ground rods which seems to be
impossible to find. Most 5/8 ground rods typically measure 0.562 so to
use
these clamps you need to make a shim. You also need to notch the 2" wide
strap to clear the bolts.
John KK9A
To:TowerTalk <TowerTalk@contesting.com>
Subject:[TowerTalk] Connecting Flat Copper to 5/8" Ground Rod
From:Ray Benny <rayn6vr@cableone.net>
Date:Sun, 13 Oct 2013 14:47:23 -0700
Has anyone come up with a way to connect flat copper straps to ground rods?
DXXE sells copper clamps w/ hardware, but at $35 a pop, I hoping that there
is a more reasonable way to get the job done.
My copper strap is 2" wide, by 6ft, and about 18 ga, but not sure.
Tnx,
Ray,
N6VR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|