Date: Tue, 23 Jul 2013 00:54:40 +0200
From: "Peter Voelpel" <dj7ww@t-online.de>
To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Which Balun with the TH7DXX
A solenoid winding made of coax is more effective then those 4 wraps.
I use SCF12-50 Cellfex to wind my choke baluns.
30 turns on a pvc tube of 4-5" diameter do the trick (2000 ohms at 14MHz).
73
Peter
## This Cellflex SCF12-50 is almost the same as Andrew superflexible
half inch heliax.
Both have a copper clad solid Aluminum center conductor + corrugated shield.
Min turning radius on this cellflex stuff is 1.3 inchs.
http://www.rfsworld.com/websearch/DataSheets/pdf/?q=SCF12-50J
## are you sure you can even wrap this stuff around a 4-5 inch diam PVC tube ?
5 inchs x 3.14 x 30 turns = 471 inchs. = 39.25 feet required. That’s one
helluva lot
of coax wasted to make a balun. With its .54 inch outer jacket X 30 turns,
the balun
ends up being 6.08 inchs OD x 16.2 inchs long. The balun would have to be
at least
3 inchs away from the boom, and 4-5 inchs would be better.
## its unique coax though. It has the smallest bend radius of all the 1/2
inch cables.
The 1.3 inch min bend radius is for repeated bending. They don’t list what
the single
bend radius is... which is typ even less than repeated bending spec.
## peter, what do you use for 40m yagi ? Is your 40 ma yagi 200 ohm..with a
1:4 balun.... or is it 50 ohm... with just a choke balun ?
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|