One turn is quoted by Fair-Rite with 190 ohms at 10MHz, 290 ohms at 25MHz
31 mix would not be my choice for a balun anyway, at least not with decent
power.
It´s curie temperature ist just over 130°C.
73
Peter
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Bert
Almemo
4-5 turns with 4 x 2.4" OD #31 ferrites is more effective than the 30 turns
on the PVC pipe! Probably double the choking impedance!
73 Bert, VE3NR
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Peter
Voelpel
Sent: Monday, July 22, 2013 6:55 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Which Balun with the TH7DXX
A solenoid winding made of coax is more effective then those 4 wraps.
I use SCF12-50 Cellfex to wind my choke baluns.
30 turns on a pvc tube of 4-5" diameter do the trick (2000 ohms at 14MHz).
73
Peter
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Jim
Thomson
## coiled up coax is not the answer either, the Z is too low. Like
gerald sez,
the wire leads on the baluns output is part of the total DE ele length.
So if using coax... factor that in...and make the Y the correct length.
## 4 wraps of 213 U around 4 x 2.4 inch OD type 31 ferrite will do
the trick
for a balun....
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|