Does that mean that the tower has to go back to UST to have such things
installed? Just curious, before I look at spending lots of $$$$ for a tower
that might need to have the same thing done a few years down the road. That
could be VERY expensive!
LJ
-----Original Message-----
>From: K7LXC@aol.com
>Sent: Mar 11, 2013 6:53 AM
>To: towertalk@contesting.com, rich@n7tr.com
>Subject: Re: [TowerTalk] US Tower HDX-689 Sheave replacement
>
>> Im looking for the 5 inch OD Pulley Sheave for the HDX-689. This is for
>the ? in cable. I need to order a few of these as I'm replacing all the
>cables on the tower right now. I know US Towers had them, but wanted to
>see if anyone else has replaced them from another vendor for a better price.
>
> Typically these are UST proprietary. That is, they make an aluminum
>sheave and then press a sealed bearing into it. You'd have to do the same
>thing.
>
>Cheers,
>Steve K7LXC
>TOWER TECH
>US Tower factory authorized installer
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|