I tried calling US Tower all day...but phone just rang. Not sure if there is a
holiday somewhere that they didn't come to work today.
I found that the bearing inside the sheave is a K10 bearing. Looks like a KP10
bearing might work but these seem to be REAL hard to locate.
Thanks for all the ideas from the list. With the amount of towers out there, I
was hoping for a stock replacement solution, but looks like this is a bit more
complicated...or expensive.
Rich
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Rich
Hallman - N7TR
Sent: Sunday, March 10, 2013 5:19 PM
To: towertalk@contesting.com
Subject: [TowerTalk] US Tower HDX-689 Sheave replacement
Im looking for the 5 inch OD Pulley Sheave for the HDX-689. This is for the ¼
in cable. I need to order a few of these as I'm replacing all the cables on
the tower right now. I know US Towers had them, but wanted to see if anyone
else has replaced them from another vendor for a better price.
Thanks...
Rich
Rich N7TR
ex KI3V, N3AMK, WB3JOV
www.n7tr.com<http://www.n7tr.com>
http://www.qrz.com/db/N7TR
Telnet: dxc.n7tr.com N7TR DXCluster
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|