That is discouraging to hear. I am hoping to order some spare bearings for my
HDX589.
I suppose contacting US Tower wouldn't do any good, they probably wont let us
know the supplier for the sheave bearings.............
On the other hand I think I will all them tomorrow and see.
Bob
K6UJ
On Mar 11, 2013, at 4:06 PM, Dan Hearn wrote:
> I have replaced the bearings on myTX472. Two bearing places in Spokane said
> that there is no replacement available with the correct ID and OD.. They
> could supply a bearing with the correct OD but the ID would be too large.
> They did have a bronze sleeve bearing with exactly the correct OD and ID to
> fill the space between the thru bolt and the available bearing. It was
> relatively easy to change the bearings and stake the edge of the sheave.
>
> Dan, N5AR
>
>
> On Mon, Mar 11, 2013 at 2:59 PM, <gdaught6@stanford.edu> wrote:
>
>>> If you heat a bearing to the flash point of the grease, you've
>>> probably
>>> already destroyed the bearing.
>>
>> There's no way I can turn the handle on my crank-up fast enough to even
>> warm the
>> grease!
>>
>> 73,
>>
>> George T Daughters, K6GT
>> CU in the California QSO Party (CQP)
>> October 5-6, 2013
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
>
> --
> Dan Hearn
> N5AR
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|