Skips suggestion is good one. After buying a couple of Force 12 antennas I
have decided to rivet all the element connections on all my antennas. I
never have to worry if the connections are going to slip. It is real easy
to drill them out if necessary to change a setting or replace part of an
element.
Bill W5VX
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
KJ6Y@aol.com
Sent: Sunday, January 27, 2013 2:26 PM
To: jerryw6uv@gmail.com; towertalk@contesting.com
Subject: Re: [TowerTalk] Hose Clamps
After tightening the clamp, you can rivet the joint. I have done that even
on the pre MFJ Hygains.
Skip, KJ6Y
_Communications Service Co_ (http://www.communicationsserviceco.com/)
818-887-3569
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|