-----Original Message-----
From: Hans Hammarquist <hanslg@aol.com>
To: towertalk <towertalk@contesting.com>
Sent: Fri, Nov 16, 2012 12:21 pm
Subject: hardline bending radius
Does anyone have a good idea of minimum bending radius for the 1/2 inch cable
TV hardline? I have been told anything from 5" to 50". I believe 5" is way too
sharp but 50"??? I sure that 50" would not cause any problems with the cable
but ...
Hans - N2JFS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|