On 11/17/2012 9:30 PM, Grant Saviers wrote:
Conduit benders are one predictable way to bend hardline and I also have
some 90 degree bend frames for half inch PEX waterlines. The PEX is
easy to kink and doesn't like to stay bent so these are made to control
and maintain the bend radius. Available at Lowes & HD. About a 6"
radius bend with them.
Don't forget the tendency of the center conductor to migrate Toward the
shield in tight bends.
73
Roger (K8RI)
Grant KZ1W
On 11/16/2012 9:21 AM, Hans Hammarquist wrote:
Does anyone have a good idea of minimum bending radius for the 1/2
inch cable TV hardline? I have been told anything from 5" to 50". I
believe 5" is way too sharp but 50"??? I sure that 50" would not
cause any problems with the cable but ...
Hans - N2JFS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|