Conduit benders are one predictable way to bend hardline and I also have
some 90 degree bend frames for half inch PEX waterlines. The PEX is
easy to kink and doesn't like to stay bent so these are made to control
and maintain the bend radius. Available at Lowes & HD. About a 6"
radius bend with them.
Grant KZ1W
On 11/16/2012 9:21 AM, Hans Hammarquist wrote:
Does anyone have a good idea of minimum bending radius for the 1/2 inch cable TV hardline? I have been
told anything from 5" to 50". I believe 5" is way too sharp but 50"??? I sure that
50" would not cause any problems with the cable but ...
Hans - N2JFS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|