I've got a 2800 rotator and a controller with a GS-23 installed. The
controller is set up so that when the rotator is fully ccw, it is at 180
degrees (south). When fully cw, it is at 270 degrees. Using Hyperterm to
query the controller, it is 180 degrees off (fully ccw=360 degrees; fully
cw= 90 degrees).
DxLabs and N1MM both show the rotator 180 degrees from its actual position.
The display on the controller matches the rotator's position.
Is there a way to change the GS-23 by 180 degrees?
Doug
K4AC
Running for ARRL SE Division Director
Campaign Website: www.k4ac.com
Campaign Blog: www.k4ac.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|