Barry,
They seem to be the same. Attached is a schematic of both styles.
73's Jim
W5IFP
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com]On Behalf Of Barry Gross
> Sent: Tuesday, October 19, 2010 9:23 AM
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] Hy-Gain rotor controllers cabling
>
>
> I've received several private replies that indicate folks aren't
> aware that Hy-Gain was installing rear panel mount 8-pin Cinch
> Jones connectors in the later Hy-Gain Ham IV rotor controllers
> instead of 8-pin terminal strips.
>
> I will proceed with the informed assumption that pin numbers 1-8
> are identically connected.
>
> Barry N1EU
>
> --- On Tue, 10/19/10, Barry Gross <n1eu@yahoo.com> wrote:
>
> > From: Barry Gross <n1eu@yahoo.com>
> > Subject: Hy-Gain rotor controllers cabling
> > To: towertalk@contesting.com
> > Date: Tuesday, October 19, 2010, 7:30 AM
> > Can anyone confirm that rotor cable
> > connection pin numbering 1-8 of a T2X terminal block is
> > identical to pin numbering 1-8 of a Ham IV cinch Jones
> > connector?
> >
> > Tnx/73,
> > Barry N1EU
> >
> >
> >
> >
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|