On 10/19/2010 10:23 AM, Barry Gross wrote:
> I've received several private replies that indicate folks aren't aware that
> Hy-Gain was installing rear panel mount 8-pin Cinch Jones connectors in the
> later Hy-Gain Ham IV rotor controllers instead of 8-pin terminal strips.
"Some" rotators are getting the Cinch Jones. The tail twister is
getting the round connector for which I've forgotten the name.
Any time I rebuild one, it's getting that new pig tail with the round
connector.
73
Roger (K8RI)
> I will proceed with the informed assumption that pin numbers 1-8 are
> identically connected.
>
> Barry N1EU
>
> --- On Tue, 10/19/10, Barry Gross<n1eu@yahoo.com> wrote:
>
>> From: Barry Gross<n1eu@yahoo.com>
>> Subject: Hy-Gain rotor controllers cabling
>> To: towertalk@contesting.com
>> Date: Tuesday, October 19, 2010, 7:30 AM
>> Can anyone confirm that rotor cable
>> connection pin numbering 1-8 of a T2X terminal block is
>> identical to pin numbering 1-8 of a Ham IV cinch Jones
>> connector?
>>
>> Tnx/73,
>> Barry N1EU
>>
>>
>>
>>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|