If I remember correctly, two nuts below the baseplate. One nut below is ok
if mortar is used below baseplate.
This was detailed in the drawing package I received.
Brad - N8SNM
----- Original Message -----
From: <K7LXC@aol.com>
To: <towertalk@contesting.com>; <fserota@msn.com>
Sent: Tuesday, April 13, 2010 2:00 PM
Subject: Re: [TowerTalk] Where should the nuts go?
>
> In a message dated 4/13/2010 10:20:10 A.M. Pacific Daylight Time,
> towertalk-request@contesting.com writes:
>
>> Just putting up a new TX455. The base plate comes with 3 nuts on each
> long
> bolt embedded in the concrete. Question is: Do 2 nut belong below the
> baseplate for locking the level, and one nut above the plate, or the
> other
> way around with one nut below and 2 nuts above?
>
> The weight of the tower will keep the bottom nuts from going anywhere.
> You double nut the top of the bolts to make sure they won't go anywhere
> either.
>
> Cheers,
> Steve K7LXC
> TOWER TECH
> UST Factory authorized installer
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|