Okay, so what's the formula to determine the adjusted wind load? Is it
straight multiply the wind load of the antenna by the height, in feet,
above the tower?
Roger (K8RI) wrote:
> John Kemker wrote:
>
>> All I'm planning on putting up on the tower is a Mosley CL-33 and a
>> W5WVO-modified Cushcraft A5-50 on top of a 15 ft. 2" dia. mast, turned
>>
>>
> Don't forget to multiply the wind load of the A5-50 by the height above
> the tower.
>
> 73
>
> Roger (K8RI)
>
>> by a Yaesu G1000SDX. Single run of LD5-50F out to tower with a coax
>> switch up near the top to switch between the two beams. I *might* top
>> it off with a 10m vertical, but then again, might just put that
>> somewhere else, like on the house.
>>
>>
>>
--
--JohnK
73 de W5NNH
10X 75371/M&M 117/SMIRK 6185/Six Club 285/TRA 2499/Norcross 228 F&AM
---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 090721-0, 07/21/2009
Tested on: 7/22/2009 2:28:50 AM
avast! - copyright (c) 1988-2009 ALWIL Software.
http://www.avast.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|