Towertalk
[Top] [All Lists]

Re: [TowerTalk] 'WWV halfwave vertical", was Vertical vs Beam

Subject: Re: [TowerTalk] 'WWV halfwave vertical", was Vertical vs Beam
From: "Gary \"Joe\" Mayfield" <gary_mayfield@hotmail.com>
Date: Mon, 6 Apr 2009 22:27:21 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I suspect the Hexbeam would meet your lightweight, performance above average
requirement.  They claim it can go on a mast.

73,
Joe kk0sd

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Richards
Sent: Monday, April 06, 2009 4:45 PM
To: jim Jarvis
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] 'WWV halfwave vertical", was Vertical vs Beam

Exactly my sentiments on these two points (see quote below)

1)   GAP has at least one antenna which employs three 25 foot 
"counterpoise" wires that are not connected to either side of the coax 
feeder... and is supposed to be of some help.  I talked to their sales 
guy at Dayton last year  and walked away unconvinced and bought another 
antenna.

2)   I understand and agree with your high and low band choice ...

Which leads me to this question:

Now.... on a small suburban lot... how small a beam, and how 
LITTLE/short/inexpensive  a mast, pole, tower, or other support would 
one want-need to get reasonably good performance  and cause the operator 
to think he was doing better than, say, using his big vertical or dipole 
(at say 35 feet high)  on the upper bands,  say on 20 M / 15M /10 M ?

In other words,  what small tribander yagi beam could one put on a on a 
light  tower or, even better,  a mast and lightweight rotator - and get 
reasonable satisfaction on the air ?    Not nirvana, but happiness.

If so, what might it look be -- I am asking how much is just enough - 
what would at the other end of the antenna spectrum from a 100 foot 
tower with the biggest M2 or SteppIR yagi beam on it.    What would be 
"good enough" (knowing it is not best) ?

For the purpose of my question, please assume all new parts, no used 
stuff, when estimating cost or suggesting what to use.   That would give 
me worst case cost scenario...

Thanks Loads.

            ==========  K8JHR  ==========

----------------------------------------------------------------------------
----
jim Jarvis wrote:

1)
>  From what I've read about vertical performance, the use of 
on-ground radials  not connected to the antenna, is of marginal value.
Possibly of  zero value.

2)
If the choice were a tribander @  50' vs. a vertical for 20... I'd
pick the beam, and go vertical for 40, 80, 160.
> 
> _______________________________________________
> 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>