Hi Dennis,
Just happen to have it - I'll send it to you by e-mail as an
attachment. This image was what got me started thinking about using a
1/2 inch drill to raise/lower the tower. I'll also post it on my web
page....you can find it here:
http://www.wd0m.com/adapter.html
73,
--
Joe Hannigan - WDØM
Pagosa Springs, CO
http://www.WD0M.com
http://www.pagosarocks.com
http://www.quiltqueen.net
Dennis Vernacchia wrote:
> Quite a few messages back someone on this reflector had posted a photo
> of a machined or welded adapter piece that could be used to couple a
> 1/2 inch Drill to the shaft of a hand Operated winch.
>
> When using the adapter I am referring to, as I recall, the winch handle was
> removed
>
> This was *NOT* the scheme shown at these web sites below
>
> http://www.wd0m.com/winchadapter.html
>
> http://www.n6rk.com/drill_adapter_for_winch/drill_applied.jpg
>
>
>
> Anyone have the photo in their archives ?
>
> 73, Dennis N6KI
> ________________
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
