| To: | w2lk@earthlink.net |
|---|---|
| Subject: | Re: [TowerTalk] How do I cut aluminum pipes? |
| From: | "Rick Karlquist" <richard@karlquist.com> |
| Reply-to: | richard@karlquist.com |
| Date: | Fri, 28 Dec 2007 17:56:08 -0800 (PST) |
| List-post: | <mailto:towertalk@contesting.com> |
See McMasterCarr SKUs: 3973A53 3973A57 6910A39 6910A57 www.mcmaster.com Rick N6RK Les Kalmus wrote: > Can you tell me which blade to look for. I take it that these are not > the diamond edge blades. > > Les W2LK > > _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Soldering flex-weave, Jim McDonald |
|---|---|
| Next by Date: | [TowerTalk] cleaning Flexweave, Craig Clark |
| Previous by Thread: | Re: [TowerTalk] How do I cut aluminum pipes?, Les Kalmus |
| Next by Thread: | Re: [TowerTalk] How do I cut aluminum pipes?, Roger (K8RI) |
| Indexes: | [Date] [Thread] [Top] [All Lists] |