This is a little OT for your question, but I do a
LOT of aluminum tubing cutting, especially irrigation
tubing. I bought a 12 inch miter saw from Harbor
Freight when it was on sale (less than $200). Then
I got an aluminum cutting blade from McMasterCarr.
Nobody sells these blades in stores.
This worked well. I also use it for plastic pipes,
which I also cut a lot of.
Rick N6RK
Gene Smar wrote:
> Alex:
>
> I use a pipe cutter, available at any hardware store, to cut aluminum
> tubing for Yagis, etc. It works really well with minimal effort and minimal
> risk of off-angle cutting as I have done with hacksaws. (I'm at the age now
> where I just buy the damn tool if I need it. Took me most of a lifetime to
> learn that lesson.)
>
>
> 73 de
> Gene Smar AD3F
>
>
> From: Alex Malyava <alex.k2bb@gmail.com>
> Date: 2007/12/07 Fri PM 12:06:25 CST
> To: towertalk@contesting.com
> Subject: [TowerTalk] How do I cut aluminum pipes?
>
> Hi guys,
> I just got an 5-BTV vertical which I gonna take to some DX country with me.
>
> I need to cut two longest pieces in order to fit it in 48" golf bag case to
> check it in.
> Is it enough to use regular hacksaw and sand the edges or there is some
> fancy tool like pipe cutter used in plumbing?
>
> I think if such tool exists I would better get one, because I have more
> "aluminum" projects in mind :)
>
> Alex K2BB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|