The PL0259 is NOT a 50 ohm connector while the "N" connector is 50 ohms.
73, Keith NM5G
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Bill Turner
Sent: Thursday, January 04, 2007 10:59 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Coax Connectors
ORIGINAL MESSAGE:
On Thu, 04 Jan 2007 09:19:35 -0500, "Roger Kissel" <kc8hz@hotmail.com>
wrote:
>Of course, we all would like to use Type Ns for the impedance
>uniformity, in comparison to the old fashioned PL-259s.
------------ REPLY FOLLOWS ------------
We would? That's news to me. PL-259s forever! :-)
73, BIll W6WRT
p.s. Solder the braid at the point where it enters the connector at the rear
end. Don't use those ridiculous little holes. Use a Weller D-550 or D-650
gun and life will be good.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|