I dont agree Bill. Difficult to clean them up when you missed the coup.....
Must be said that nowadays one can find nice good and cheap N , nomore
soldering necessary.
Jos on4kj
-----Message d'origine-----
De : towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] De la part de Bill Turner
Envoyé : jeudi 4 janvier 2007 16:59
À : towertalk@contesting.com
Objet : Re: [TowerTalk] Coax Connectors
ORIGINAL MESSAGE:
On Thu, 04 Jan 2007 09:19:35 -0500, "Roger Kissel" <kc8hz@hotmail.com>
wrote:
>Of course, we all would like to use Type Ns for the impedance
>uniformity, in
>comparison to the old fashioned PL-259s.
------------ REPLY FOLLOWS ------------
We would? That's news to me. PL-259s forever! :-)
73, BIll W6WRT
p.s. Solder the braid at the point where it enters the connector at the rear
end. Don't use those ridiculous little holes. Use a Weller D-550 or D-650
gun and life will be good. _______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|