Take the MFJ-269 and put it in the mode you use to find distance to faults.
Then take the two phasing lines, short them at the ends, and verify that
they have nulls at the same frequency. That verifies that they have the same
electrical length.
73, Jerry K0TV
----- Original Message -----
From: "Gregg Seidl" <k9kl@centurytel.net>
To: <TowerTalk@contesting.com>
Sent: Sunday, April 02, 2006 7:55 PM
Subject: [TowerTalk] phasing
>I would like to know if there is a way to check phasing of antennas.I'm in
> the process of installing 2 M2 6M-7JHV's.I am using a Comtek stack-match
> made for 6 meters.Is there a way to check that the phasing is right.I have
> antennas stacked for the other bands 2m.432 1296 and 2304 but never really
> CHECKED to see if the phasing is right.Any ideas.I have some test gear but
> quite limited really.MFJ-269B and of course an ohm meter. Gregg K9KL
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|