Gregg, one point I would make is to never trust the wiring provided by the
antenna OEM. Years ago I put up a 4 yagi EME array using CC antennas and
ASSumed that they wired every antenna the same way. After realizing some
poor performance and taking off the lids to the protective covers on the
matching networks for each antenna I saw one of them was 180 degrees out of
phase. Always double check every wire starting at the driven element.
73
Gedas
online image gallery at http://gedas.cc
e-mail address at w8bya (at) mchsi (dot) com
web page at http://www.w8bya.com
----- Original Message -----
From: "Gregg Seidl" <k9kl@centurytel.net>
To: <TowerTalk@contesting.com>
Sent: Sunday, April 02, 2006 7:55 PM
Subject: [TowerTalk] phasing
>I would like to know if there is a way to check phasing of antennas.I'm in
> the process of installing 2 M2 6M-7JHV's.I am using a Comtek stack-match
> made for 6 meters.Is there a way to check that the phasing is right.I have
> antennas stacked for the other bands 2m.432 1296 and 2304 but never really
> CHECKED to see if the phasing is right.Any ideas.I have some test gear but
> quite limited really.MFJ-269B and of course an ohm meter. Gregg K9KL
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|