I have all ready fought the good fight with the zoning board and have the
building permit in hand.
Thanks to everyone for their input. Just a side note, I received no direct
posts that weren't cc's to the list.
Pat, K8PC
----- Original Message -----
From: "Alan C. Zack" <k7acz@cox.net>
To: <w2lk@earthlink.net>
Cc: <hdmc38@bellsouth.net>; <towertalk@contesting.com>; "Pat Chiles"
<chilesp@adelphia.net>
Sent: Thursday, July 22, 2004 6:58 PM
Subject: Re: [TowerTalk] Hole Digging Question
> US Towers only rates their towers to UBC-97 specs at 70 MPH. Many
> states/county/city Bldg Depts now require IBC-2000 90 MPH wind calcs.
> I tried for 5 months to get 90 MPH wind calcs out of US Towers to
> satisfy my Bldg Dept and after going back and forth with their
> out-sourced PE I was told their towers cannot be rated under IBC-2000
> specs. My suggestion is to check with your Bldg Dept for their
> requirements BEFORE ordering a tower.
>
> Les Kalmus wrote:
>
> > My 89 ft tower needs a 5x5x8 hole per the US Tower drawing.
> >
> > Les W2LK
> >
> > -----Original Message-----
> > From: towertalk-bounces@contesting.com
> > [mailto:towertalk-bounces@contesting.com]On Behalf Of Alan C. Zack
> > Sent: Thursday, July 22, 2004 4:47 PM
> > To: hdmc38@bellsouth.net
> > Cc: towertalk@contesting.com; Pat Chiles
> > Subject: Re: [TowerTalk] Hole Digging Question
> >
> >
> > A 5' X 5' X 8' base sounds kinda small for a 72 ft tower. What wind
> > calcs are you using? Did your Bldg Dept ask for wind calcs with your
> > application? Just asking to save you future problems.
> > GL
> >
> > hdmc38@bellsouth.net wrote:
> >
> >>It would be on my job Pat.
> >>
> >> 73 Joe K4XZ
> >>
> >>
> >>>From: "Pat Chiles" <chilesp@adelphia.net>
> >>>Date: 2004/07/22 Thu AM 10:26:52 EDT
> >>>To: <towertalk@contesting.com>
> >>>Subject: [TowerTalk] Hole Digging Question
> >>>
> >>>I will be starting a tower project in about a month. It will be a 72
FT
> >
> > crank-up and the specs call for a foundation that is 5ftx5ftx8ft. Is it
> > reasonable to expect a back-hoe operator to be able to dig this size
whole
> > without elongating it beyond 5ftx5ft?
> >
> >>>Pat, K8PC
> >
> >
> >>
> >>JOE PATRICK
> >>SENIOR PLUMBING/MECHANICAL
> >>INSPECTOR CITY OF BOYNTON BEACH
>
> --
> __________________________________________________________________________
>
> Alan Zack
> Amateur Radio Station K7ACZ
> Las Vegas, Nevada, USA
> Quality Engineer, The Boeing Company, Retired
> Aviation Chief Warrant Officer, U.S. Coast Guard, Retired
> U.S. Coast Guard, Always Ready, Always There
> Every hour, Every day, Around the Clock and Around the World
> SEMPER PARATUS
> http://gocoastguard.com
>
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|