Towertalk
[Top] [All Lists]

[TowerTalk] Rotor Wiring Sequence Help

To: <towertalk@contesting.com>
Subject: [TowerTalk] Rotor Wiring Sequence Help
From: kb9yku@comcast.net (kb9yku)
Date: Fri Aug 1 11:47:11 2003
if there is biger wires  thay go on the motor I WOULD think
kb9yku

----- Original Message ----- 
From: <K7LXC@aol.com>
To: <knesbitt@nucleus.com>; <towertalk@contesting.com>
Sent: Friday, August 01, 2003 9:00 AM
Subject: Re: [TowerTalk] Rotor Wiring Sequence Help


> In a message dated 7/31/03 9:21:43 PM Pacific Daylight Time,
> knesbitt@nucleus.com writes:
>
> > I have an old CDE TR-44 rotator that I am planning on putting up this
> >  summer. Unfort. I have misplaced the "stone tablet" data sheet showing
the
> >  wiring interconnect.
> >  It is an 8 wire unit and was hoping someone might be able to tell me
what
> >  the correct wiring sequence is between the control head and the rotor
unit
> >  itself.
>
>     Sure - connect control box terminal 1 to rotator terminal 1, 2 to 2, 3
to
> 3, etc.
>
>     If you've got any of the plug pigtails, then you'll need the specific
> pin-out for the plugs.
>
> Cheers,
> Steve     K7LXC
> TOWER TECH
> _______________________________________________
>
> See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>


<Prev in Thread] Current Thread [Next in Thread>