In a message dated 7/31/03 9:21:43 PM Pacific Daylight Time,
knesbitt@nucleus.com writes:
> I have an old CDE TR-44 rotator that I am planning on putting up this
> summer. Unfort. I have misplaced the "stone tablet" data sheet showing the
> wiring interconnect.
> It is an 8 wire unit and was hoping someone might be able to tell me what
> the correct wiring sequence is between the control head and the rotor unit
> itself.
Sure - connect control box terminal 1 to rotator terminal 1, 2 to 2, 3 to
3, etc.
If you've got any of the plug pigtails, then you'll need the specific
pin-out for the plugs.
Cheers,
Steve K7LXC
TOWER TECH
|