In a message dated 99-08-13 09:23:18 EDT, rhealy@adaptivebroadband.com writes:
> I have a Tailtwister with the 8-pin Amp (round, twist-lock) connector. The
> control box has a Cinch-Jones connector. The manual I got with the rotator
> doesn't show these connector pinouts, so I'd appreciate hearing from anyone
> who has the pinout information (or a link to it) so I can wire the
> connectors and get the upper antennas spinning on the back tower! Thanks in
> advance.
Hi, Rus --
It's just 1 to 1, 2 to 2, 3 to 3, etc.
The wires for the Amp connector need to be the same length with the
pins on them. Push them in (when you're done soldering) until they 'click'.
Unless you have a pin extractor, this is a one-time, non-reversible operation
so be sure you're ready to go. Or wait until you've got an extractor.
Cheers, Steve K7LXC
Cheers, Steve K7LXC
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|