[TowerTalk] 4 point guying...how?

[K7LXC@aol.com (K7LXC@aol.com)]

In a message dated 99-04-01 08:30:52 EST, SavageBR@aol.com writes:

> Rohn makes a set of guy arms for 4 point guying. One is a Y shaped arm that
>  bolts to the standard guy bracket and give you two guy arms at 90 degrees. 
> The
>  other two guy arms are like a torque arm with a formed angle. They each
bolt
>  to the std guy bracket and due to the angle, provide a 90 degree guy angle.
>  
>  This hardware is normally used on their  FK25G tiltover towers for 90 deg
>  guys.
>  Sorry I don't have the part numbers.

      It looks like it's part of the hinge section so it's not available by
itself. With some proper engineering and a clever welder you could fabricate a
suitable guy bracket yourself. 

Cheers,  Steve   K7LXC

Cheers,   Steve   K7LXC

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm