Hi Buddy,
the adhesive used on the electrical tape can eat away at the heat shrink
tubing. I never use the two together. In this situation, I would normally
use electrical tape coated with Scothkote.
Jim Smith
KQ6UV
-----Original Message-----
From: F.R. Ashley <frashley@netpath.net>
To: Towertalk@contesting.com <Towertalk@contesting.com>
To: <towertalk@contesting.com>
Date: Tuesday, October 27, 1998 11:09 AM
Subject: [TowerTalk] Hygain cinch plug corrosion
>
>Hello all,
>
>I just checked the cinch plug on my Hygain Ham IV rotor and it was green
>with corrosion! When I installed the new rotor back in May of this year, I
>used the heat shrink tubing, wrapped this with electrical tape, then
>covered this with a layer of plastic tape, followed with another layer of
>electical tape. I thought I had done a pretty decent job of
>"waterproofing" my cinch plug, but was amazed at the amount of corrosion
>after only 6 months. After seeing this, I think the old screw terminals
>are better!
>
>My question is how or what can I use to better protect this plug? Is there
>any special waterproof tapes available that are REALLY waterproof?
>All suggestions appreciated!
>73 de WB4M
>Buddy
>
>--
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Submissions: towertalk@contesting.com
>Administrative requests: towertalk-REQUEST@contesting.com
>Problems: owner-towertalk@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|