Hi All
I have never had a problem with N Connectors. Had soldering problems with
UHF plus there are a lot of nice switches that have N connectors, that are
good bargains. Don't go to XYZ9 for your switches.
My 2 cents
N7RT
-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Charles
Moizeau
Sent: Thursday, October 20, 2016 5:34 PM
To: Topband
Subject: Re: Topband: inv. L
Before putting any kind of tape, gunk or goo on a fitting or soldered
connection with the expectation of weatherproofing it in an outdoor
environment, I ALWAYS do this first: I wrap the item with two layers of
half-inch wide 3-M blue tape used by painting contractors and widely
available. This product has very little tensile strength, but that is not
needed in this application. Its virtue is that, unlike almost every other
tape, the adhesive never separates from the tape backing, with the result
that even after years the protected item will be kept squeaky clean and
uncontaminated by whatever was placed on top of it during the initial
weatherproofing treatment.
I learned this after suffering the vexations of using liquid solvents in
often unsuccessful attempts to fully clean up and disassemble a fitting or
soldered joint covered with a variety of weatherproofing products, parts of
which had migrated into the connection, mechanical or soldered.
73,
Charles, W2SH
________________________________
From: Topband <topband-bounces@contesting.com> on behalf of Art Snapper
<art@nk8x.net>
Sent: Thursday, October 20, 2016 9:16 AM
To: 160
Subject: Re: Topband: inv. L
I had a few hours free yesterday afternoon, so I began the dual 80/160
radiator inv. L project.
In the process, I found that water had entered the coaxial center insulator
that was used at the feedpoint of the antenna.
Does anyone have a favorite solution for a weatherproof, coaxial feedpoint
for this type of antenna???
The radials are attached to several load center ground bars, that are
screwed into a copper pipe that is driven into the ground.
The pipe gives me a rigid mounting point for some kind of insulator or
standoff.
BTW, after a temporary fix, I ran some quick SWR tests. There appears to be
very little interaction between the elements. At least from an SWR
perspective.
de Art NK8X
?
On Mon, Oct 17, 2016 at 11:16 AM, Art Snapper <art@nk8x.net> wrote:
> I was considering adding a second vertical element to my 160 inverted L.
> This one would be roughly a quarter wave tall for use on 80.
>
> I tried modelling in Eznec, but wasn't comfortable with the results. I
> may have screwed it up.
>
> Has anyone tried it for real? Is it a big compromise on either band?
> Would a switch at the feedpoint have any benefit?
>
> My inverted L has about 50 radials.
>
> 73
> Art NK8X
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
Topband Archives - Contesting Online
Home<http://www.contesting.com/_topband>
www.contesting.com
Topband Mailing List Archives. Search String: [How to search] Display: ...
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
Topband Archives - Contesting Online
Home<http://www.contesting.com/_topband>
www.contesting.com
Topband Mailing List Archives. Search String: [How to search] Display: ...
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|