| To: | Martin <dm4im@t-online.de> |
|---|---|
| Subject: | Re: Topband: Restistance of wire |
| From: | k1fz@myfairpoint.net |
| Reply-to: | k1fz@myfairpoint.net |
| Date: | Wed, 03 Dec 2014 12:05:26 -0500 |
| List-post: | <topband@contesting.com">mailto:topband@contesting.com> |
The resistance sounds about right Martin. Most of the conductivity
comes from the copper strands.
Steel strands have high mechanical strength, but poor conductivity.
I square R loss is low as signal current is very low.
73 Bruce-K1FZ www.qsl.net/k1fz/beveragenotes.html The length of the beverage is about 200m. To my surprisei measure about 25Ohms with a Multimeter at the feed end of the beverage. 73, Martin DM4iM _________________ Topband Reflector Archives - http://www.contesting.com/_topband _________________ Topband Reflector Archives - http://www.contesting.com/_topband |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Topband: Restistance of wire, Bill Wichers |
|---|---|
| Next by Date: | Re: Topband: Restistance of wire, Tom W8JI |
| Previous by Thread: | Re: Topband: Restistance of wire, Bill Wichers |
| Next by Thread: | Re: Topband: Restistance of wire, Tom W8JI |
| Indexes: | [Date] [Thread] [Top] [All Lists] |