Topband
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: Topband: Feedpoint of short RX vertical

from [dl8yhrfrank--- via Topband] [Permanent Link][Original]
To: topband@contesting.com
Subject: Re: Topband: Feedpoint of short RX vertical
From: dl8yhrfrank--- via Topband <topband@contesting.com>
Reply-to: dl8yhrfrank@aol.com
Date: Sat, 7 Jun 2014 15:23:12 -0400 (EDT)
List-post: <topband@contesting.com">mailto:topband@contesting.com> 
hi luc
so you use a hi z rx arrya and you have matched the 7m long radials with a coil 
in resonaze?
VY 73
frank
 

 



-----Ursprüngliche Mitteilung----- 
Von: luc kerkhofs via Topband &lt;topband@contesting.com&gt;
An: topband &lt;topband@contesting.com&gt;
Verschickt: Sa, 7 Jun 2014 9:13 pm
Betreff: Topband: Feedpoint of short RX vertical

 
 
 
Hello, 
  
trying to improve my RX setup, I have a question . 
  
When feeding short RX verticals with a coil and resistor in series, does it 
make  
sense to decouple the feedline 
at the feedpoint with a braid breaker ? 
  
73 
Luc 
ON4IA 
_________________ 
Topband Reflector Archives - http://www.contesting.com/_topband 
 

  

_________________
Topband Reflector Archives - http://www.contesting.com/_topband
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: Topband: Feedpoint of short RX vertical, donovanf
Next by Date:  Re: Topband: Feedpoint of short RX vertical, Tom W8JI
Previous by Thread:  Re: Topband: Feedpoint of short RX vertical, donovanf
Next by Thread:  Re: Topband: Feedpoint of short RX vertical, donovanf
Indexes:  [Date] [Thread] [Top] [All Lists]