I've read good things about the Wellbrook Ashton, but I've not had much
success with various types of loops over the years and the Wellbrook is
big bucks; more than I'm willing to put out if it turns out not to be
successful for me.
Brian VE7JKZ
On 9/18/2013 8:01 AM, Ashton Lee wrote:
I use a Wellbrook loop for receive and it is really effective vs my transmit antenna.
I also have a 300 foot Beverage on Ground (BOG)… early in the evening the loop
seems to work best, later often the BOG. But if you are space constrained the
Wellbrook works darn well.
On Sep 18, 2013, at 8:45 AM, Brian_ve7jkz <ve7jkz@telus.net> wrote:
I wonder too if it's worth the effort, Grant, OTOH there's not much to lose for
a few hours work to install and then try out. I've tried various loops and
things over the years and the BC band filter from the 1996 ARRL Handbook - and
probably later - does an excellent job. I've used my N2PK analyzer to sweep it
and it is indeed 60dB attenuation across the BC band, better in some places.
Playing around with some of the softrock radios where the BC station really
killed 'em a 690Khz notch filter did a good job as well.
Brian VE7JKZ
On 9/17/2013 10:39 PM, Grant Saviers wrote:
Not an expert by any means, but I wonder if it is worth the effort to match the
antenna to the feedline? Local and band noise and your NVIS pattern say to me
that gain isn't a problem, then there is the YIKES! of 50kw so close, so you
need a killer HP filter. Have you tried one? I had plenty of rf from a 50kw
station 1 mile away line of sight to my 80m vertical, and yes my dipole at 60'
was quieter, but still needed a HP filter. 1 volt of 1MHz BC signal on my
power lines and good line filters were needed also.
Here is a nice article on receive transformers which can help plan a step up
design.
http://www.dxing.info/equipment/impedance_matching_bryant.pdf
OTOH, I have a DX eng receive only 4sq, 70' on a side, no BC problems at a new
QTH, no radials and it works quite well on 160/80. Not cheap, but effective
and might fit on your lot.
Grant KZ1W
On 9/17/2013 8:38 PM, Brian_ve7jkz wrote:
I've been looking at a very low dipole to hopefully assist in receiving. Living
in suburbia space is limited but thanks to a helpful neighbor I could put up
something in the shape of an L. I would have a 90ft straight length, then the
feedpoint, then a 30ft straight length, a 90 degree turn, followed by another
60 ft straight length. Total length of 180ft approx. Running along the top of
the garden fence approx 6ft high.
EZNEC 3 tells me that at 1.83Mhz the feedpoint impedance would be 0.65-j590,
and at 3.52Mhz it would be 1.7+j510. How do I match it? I could always use a
relay to switch in some L for 160m and some C for 80m, then a transformer to
get to close to 50 ohms, then a high pass filter because I'm only a few hundred
yards from a 50kW BC station on 690Khz, followed by a W7IUV amplifier.
Is this a reasonable approach or is there a better/simpler way?
Brian VE7JKZ
_________________
Topband Reflector
_________________
Topband Reflector
_________________
Topband Reflector
|