Hi, Herb
I went off and read from Earl's K6SE's writings about the FO0AAA low-band RX
antenna.
The following is an excerpt from those writings:
"It is a close relative of the Pennant and Flag antennas, which are
ground-independent relatives of the Ewe. The Delta is a modification of the
"delta-shaped Ewe loop" shown in figure 7-66 on page 7-51 of ON4UN's new
Low-Band DXing book.
I took John's Delta-Ewe and, with the feedpoint and termination located at
the bottom corners of the triangle, I used EZNEC to optimize the design for
best F/B and zero reactance at 1.830 mHz. This is the design that was built
by ON4UN for use by FO0AAA."
I guess that explains why, in my mind and memory, I had associated the
antenna with John, ON4UN.
73,
Charlie, K4OTV
-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Herb
Schoenbohm
Sent: Tuesday, September 10, 2013 1:04 PM
To: topband@contesting.com
Subject: Re: Topband: 3B9EME
The FO0AAA 160 RX antenna was put together for the operation by Earl
Cunningham (SK) K6SE. Earl even wrote a detailed article on the design for
QST.
Herb, KV4FZ
On 9/10/2013 10:24 AM, n0tt1@juno.com wrote:
> On Mon, 9 Sep 2013 22:44:45 -0400 "Charlie Cunningham"
> <charlie-cunningham@nc.rr.com> writes:
>> Valid points, Keith.
>>
>> I think the boys that went to FO0AAA did good to hang up that KAZ
>> terminated Loop that John, ON4UN, put together for them!
> <snip>
>
> And FYI....there was no receiving amplifier used with that antenna on
> Clipperton.
>
> 73,
> Charlie, N0TT
> 1 of 12 FO0AAA Oprs.
>
> _________________
> Topband Reflector
_________________
Topband Reflector
_________________
Topband Reflector
|