Topband
[Top] [All Lists]

Topband: Shunt feeding caps.

To: <topband@contesting.com>
Subject: Topband: Shunt feeding caps.
From: price.smith@worldnet.att.net (Harold Smith)
Date: Sat, 7 Dec 2002 17:34:36 -0600
Bob:

I will agree with John, G3XRU. I don't think ceramic capacitors are the way
to go.

I even had a problem with air varible capacitors at 1500 watts. The plates
would warp and short out. I went to vacuum variables and no problems.

My matching network is in a 18 X 18 X 6 inch waterproof box screwed to the
base of my 80 ft tower. I use 2-500pf 7500volt vacuum varible capacitors.

73 de
Price WØRI and Club WØCKC

----- Original Message -----
From: Bob Marzari <w3pt@itech.net>
To: <topband@contesting.com>
Sent: Friday, December 06, 2002 3:56 PM
Subject: Topband: Shunt feeding caps.


> Hi, I am looking for advice on replacing the 250pF bread-slicer used in my
> 160M Gamma match with a fixed value cap and therefore reducing the size of
> the NEMA box at the base of the tower. I am at about half mesh on the
> bread-slicer and am thinking about ceramic doorknobs as a replacement. Run
> 1KW to it. Are there any caveats?
>
> Bob, W3PT
>
>
>
> _______________________________________________
> Topband mailing list
> Topband@contesting.com
> http://lists.contesting.com/mailman/listinfo/topband
>


<Prev in Thread] Current Thread [Next in Thread>