You could move the filter to another position to see if the filter or the
switching to that filter slot is at fault If the Orion works like the Omni
VI there may be some bandpass shift or BFO adjustments necessary to make it
work.
On Thu, May 29, 2025, 11:35 AM Michael Marx <sndtubes@vacuumtubes.com>
wrote:
> I have a newly acquired Orion 1. The filter board is loaded. The
> optional filters were not enabled in the menu. When Inenabled them, the
> radio would go nearly dead when the 500 Hz filter was switched in. I
> tried another filter and got the same result. Then I did a full reset.
> Problem still existed.
>
> There are diodes on the input and output of the filter. There also
> appears to be a matching network. I am suspecting the diodes. Have any of
> you seen this type of failure or symptom. What was the remedy? I am
> guessing they are SMT components on the bottom of the board. Is the
> FILTER BOARD hard to remove?
>
> TIA
> 73
> Mike WB0SND
>
>
>
>
> Michael Marx
> SND Tube Sales
> www.vacuumtubes.com
> 636-939-9190
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|